Skip to main content

はじめに

This guide will help locate the motherboard for removal and/or repair.

パーツ

パーツは指定されていません。

  1. Flip over the phone and then slide down the back cover with your thumb.
    • Flip over the phone and then slide down the back cover with your thumb.

  2. Lever out the battery from the phone using your thumb.
    • Lever out the battery from the phone using your thumb.

  3. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
    • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

  4. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  5. Gently pull off hinge cap piece from the the top of the phone.
    • Gently pull off hinge cap piece from the the top of the phone.

  6. Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
    • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

  7. Open the phone and turn it on its side. Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
    • Open the phone and turn it on its side.

    • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

  8. Using your hand, gently pull of the back panel from the bottom half of the phone.
    • Using your hand, gently pull of the back panel from the bottom half of the phone.

  9. Close the phone and place it on a flat surface.
    • Close the phone and place it on a flat surface.

    • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

    • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

  10. On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
    • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

    • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Andrew

メンバー登録日: 2010年10月04日

376 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 4-46, Amido Fall 2010 Cal Poly, Team 4-46, Amido Fall 2010人のメンバー

CPSU-AMIDO-F10S4G46

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 211