メインコンテンツにスキップ

Monster SoundStage S1 Mini Speaker Replacement

必要な工具と部品

  1. Monster SoundStage S1 Mini Speaker Replacement, Speaker: 手順 1、 2の画像 1 Monster SoundStage S1 Mini Speaker Replacement, Speaker: 手順 1、 2の画像 2
    • Remove the speaker wires from the motherboard by pinching the plastic tab at the end of the cable and pulling towards you.

  2. Monster SoundStage S1 Mini Speaker Replacement: 手順 2、 2の画像 1 Monster SoundStage S1 Mini Speaker Replacement: 手順 2、 2の画像 2
    • Unscrew 1.2 cm Torx security screw, holding the silver circle connector, to disconnect the wire from the speakerboard to the motherboard

  3. Monster SoundStage S1 Mini Speaker Replacement: 手順 3、 1の画像 1
    • Remove the black putty from the speaker wires at both ends of the speaker board.

  4. Monster SoundStage S1 Mini Speaker Replacement: 手順 4、 3の画像 1 Monster SoundStage S1 Mini Speaker Replacement: 手順 4、 3の画像 2 Monster SoundStage S1 Mini Speaker Replacement: 手順 4、 3の画像 3
    • Solder the black plastic encasing the red and black wires.

  5. Monster SoundStage S1 Mini Speaker Replacement: 手順 5、 2の画像 1 Monster SoundStage S1 Mini Speaker Replacement: 手順 5、 2の画像 2
    • Remove both the black and red wires with pliers

    • Pliers may stick to speaker because it is magnetic.

  6. Monster SoundStage S1 Mini Speaker Replacement: 手順 6、 2の画像 1 Monster SoundStage S1 Mini Speaker Replacement: 手順 6、 2の画像 2
    • Tuck wires through the hole where the speaker is located, then gently push the speaker out.

    • The 1.2 cm Torx security screws that stayed in place near the speaker will now fall out.

    • To remove the other speaker repeat steps 3-6

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

作成者

3人の作成者と共同で作成されました。

Heather Carrillo

メンバー登録日: 09/12/16

412 ポイント

2のガイドは作成済み

チーム

CSU Fullerton, Team 2-6, Bruce Fall 2016 CSU Fullerton, Team 2-6, Bruce Fall 2016人のメンバー

CSUF-BRUCE-F16S2G6

4 メンバー

7のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 1

今までの合計 484