メインコンテンツにスキップ
  1. Start off by unpeeling the black display cover over the sensor board.
    • Start off by unpeeling the black display cover over the sensor board.

    • Do not worry, the display board will re-stick when reassembling.

  2. Unscrew the two 3mm Torx Security #6 screws on the edge of the device. Unscrew the two 5mm Torx Security #10 in the middle of the device.
    • Unscrew the two 3mm Torx Security #6 screws on the edge of the device.

    • Unscrew the two 5mm Torx Security #10 in the middle of the device.

  3. Lay the device on its back and unpeel the silicone base. Unscrew the four 5mm Torx Security #10 at base. Unscrew the four 5mm Torx Security #10 at base.
    • Lay the device on its back and unpeel the silicone base.

    • Unscrew the four 5mm Torx Security #10 at base.

  4. Gently remove the metal screen. Gently remove the metal screen.
    • Gently remove the metal screen.

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Akshar Patel

メンバー登録日: 2016年09月12日

228 ポイント

1ガイドが承認済み

チーム

CSU Fullerton, Team 2-6, Bruce Fall 2016 CSU Fullerton, Team 2-6, Bruce Fall 2016人のメンバー

CSUF-BRUCE-F16S2G6

4 メンバー

4のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 247