はじめに

Looks as though some experience with a soldering tool may be necessary, so make sure to be safe with these steps!

First, apply pressure with your thumb on the top of the battery cover.
  • First, apply pressure with your thumb on the top of the battery cover.

コメントを追加する

Next, pull down on the cover until it begins to slide.
  • Next, pull down on the cover until it begins to slide.

コメントを追加する

Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).
  • Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).

コメントを追加する

Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
  • Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.

コメントを追加する

Detach back part of the case by gently lifting up.
  • Detach back part of the case by gently lifting up.

コメントを追加する

Remove the circuit board from the front part of the radio case.
  • Remove the circuit board from the front part of the radio case.

  • Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.

コメントを追加する

Scrape off the glue on the outer lining of the speaker using the metal spudger.
  • Scrape off the glue on the outer lining of the speaker using the metal spudger.

コメントを追加する

Pry the speaker from the case using the metal spudger.
  • Pry the speaker from the case using the metal spudger.

  • This should not take excessive force, so make sure all remaining glue is scraped off from the edges if it will not easily come out.

コメントを追加する

The speaker is now disassembled!
  • The speaker is now disassembled!

コメントを追加する

Solder the new wires to the circuit board in the spots denoted by the two red circles.
  • Solder the new wires to the circuit board in the spots denoted by the two red circles.

コメントを追加する

Place the speaker back inside the shell casing in the same way that it was originally placed.
  • Place the speaker back inside the shell casing in the same way that it was originally placed.

  • Accurately use a polyurethane glue around the rim of the speaker to mount it firmly back inside the plastic casing.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

James Tucker Dunn

メンバー登録日: 2013年01月18日

371 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 19-43, Regan Winter 2013 Cal Poly, Team 19-43, Regan Winter 2013人のメンバー

CPSU-REGAN-W13S19G43

3 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 1

今までの合計 570