MiTM Pressure Washers CA2703HDHB1 2017 Recoil Starter Replacement

はじめに

This guide shows how to remove and replace the entire recoil starter assembly. The assembly is an OEM part for Honda GX200 engine models.

If you replace the recoil starter with a non-OEM part, you may have to remove the starter cap. For that, you will need the following additional tools:

3/4” deep socket

必要な工具と部品

手順1 Remove the recoil starter bolts

MiTM Pressure Washers CA2703HDHB1 2017 Recoil Starter Replacement, Remove the recoil starter bolts: 手順 1、 1の画像 1

Before you begin, be sure that the engine is powered off and is cool to the touch.
Use a 10 mm socket to remove the three 24 mm long bolts.

翻訳

手順2 Remove the recoil starter assembly

MiTM Pressure Washers CA2703HDHB1 2017 Recoil Starter Replacement, Remove the recoil starter assembly: 手順 2、 1の画像 1

Remove the recoil starter assembly.

翻訳

手順3

If you are replacing the assembly with a non-OEM part, you may also have to replace the starter cap.
Remove the 3/4" bolt with a deep socket.
This bolt can be very difficult to remove. Use the hook as a bracing point to keep the starter cap from rotating.