メインコンテンツにスキップ

はじめに

Use this guide to remove or replace the belt guard bracket on a Mi-T-M Air Compressor AM1-PH65-08HD 2012.

This is a prerequisite-only guide. This guide is part of another procedure and is not meant to be used alone.

パーツ

パーツは指定されていません。

  1. Use a 7/16 inch socket to remove the nuts and accompanying bolts securing the belt guard bracket to the rear belt guard.
    • Use a 7/16 inch socket to remove the nuts and accompanying bolts securing the belt guard bracket to the rear belt guard.

    • You may need to hold the bolts in place with a 7/16 inch wrench during removal.

    • Don't misplace the washers that are removed during this step.

    • During reassembly, you may need to slightly loosen the two head bolts securing the belt guard bracket in order to properly align the bracket with the mounting holes in the rear belt guard.

  2. Use a 1/2 inch socket to remove the two bolts securing the belt guard bracket to the cylinder head.
    • Use a 1/2 inch socket to remove the two bolts securing the belt guard bracket to the cylinder head.

    • Don't lose the loosened spacers underneath the belt guard bracket.

    • Don't misplace the washers that are removed during this step.

  3. Lift the belt guard bracket straight up to remove it. Lift the belt guard bracket straight up to remove it.
    • Lift the belt guard bracket straight up to remove it.

  4. Remove the four spacers from the top of the cylinder head. Remove the four spacers from the top of the cylinder head.
    • Remove the four spacers from the top of the cylinder head.

終わりに

To reassemble your device, follow these instructions in reverse order.

Kyle Smith

メンバー登録日: 2021年02月01日

12,961 ポイント

62のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

137 メンバー

16,038のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 15