メインコンテンツにスキップ

MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement, Optical Drive: 手順 1、 1の画像 1
    • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the logic board.

  2. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 2、 1の画像 1
    • Disconnect the camera cable by pulling its connector away from the socket (toward the optical drive) on the logic board.

  3. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 3、 1の画像 1
    • Use the flat end of a spudger to pry the optical drive connector up off the logic board.

  4. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 4、 2の画像 1 MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 4、 2の画像 2
    • Remove the two Phillips screws securing the AirPort/Bluetooth board housing.

    • Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case.

  5. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 5、 1の画像 1
    • Remove the following three Phillips screws securing the optical drive to the upper case:

    • One 4.5 mm Phillips screw securing the optical drive bracket to the upper case near the fan.

    • Two 2.5 mm Phillips screws securing the optical drive to the upper case near the optical drive opening.

  6. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: 手順 6、 1の画像 1
    • Lift the optical drive near its connector and pull it away from the upper case to remove it from the computer.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

6人の作成者と共同で作成されました。

Walter Galan

694,692 ポイント

1,203のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 956