メインコンテンツにスキップ

この修理ガイドは変更されています。最新の未承認バージョンに切り替えます。

MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: 手順 1、 2の画像 1 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: 手順 1、 2の画像 2
    • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

    • Pull the connector parallel to the face of the logic board, not straight up.

    • Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board.

  2. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: 手順 2、 2の画像 1 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: 手順 2、 2の画像 2
    • Remove the two 8 mm Phillips screws securing the Bluetooth/camera cable retainer to the upper case.

    • One of the screws may remain captive in the Bluetooth/camera cable ground loop. If replacing the display, be sure to transfer this screw to the new unit.

    • Lift the Bluetooth board/cable retainer assembly out of the upper case.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

5人の作成者と共同で作成されました。

Walter Galan

693,920 ポイント

1,203のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,861