はじめに

Have your MacBook Pro feet seen better days? Use this guide to give your early 2013 MacBook Pro a fresh set of feet.

    • Remove the following ten screws securing the lower case to the upper case:

      • Two 2.3 mm P5 Pentalobe screws

      • Eight 3.0 mm P5 Pentalobe screws

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

    コメントを追加する

  1. Wedge your fingers between the upper case and the lower case.
    • Wedge your fingers between the upper case and the lower case.

    • Gently pull the lower case away from the upper case.

    • Remove the lower case and set it aside.

    コメントを追加する

    • The lower case is connected to the upper case at the center, with two plastic clips.

    • During reassembly, gently push down the center of the lower case to reattach the two plastic clips.

    コメントを追加する

    • Peel away any stickers from the backside of the rear case covering the feet you have chosen to replace.

      • Any stickers you remove will most likely be unsalvageable for re-use. That's okay! Your MacBook does not need them to function.

    コメントを追加する

  2. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Remove any broken or damaged feet.

      • If the foot you are replacing is still intact, you can use your tweezers push it out from the inside.

    • If the old foot is difficult to remove, use a hair dryer or a heat gun to apply some heat to the area and loosen the adhesive.

    コメントを追加する

    • Scrub the foot cavity with adhesive remover to remove any remaining adhesive.

    コメントを追加する

    • Wipe the foot cavity with an isopropyl alcohol prep pad to remove any cleaner residue and prep the area for the adhesive on the new foot.

    コメントを追加する

    • Peel a replacement foot from the plastic backing.

      • The adhesive is fairly strong—make sure that you are peeling the foot up, not tearing the plastic backing.

    コメントを追加する

    • Align the new foot inside the cavity.

      • Make sure the alignment nub on the foot is lined up with the small hole near the perimeter of the pad.

    • Lay the foot down while keeping it properly aligned.

    • Check for proper alignment from the inside of the case. The alignment nub should be slightly visible through the alignment hole.

    コメントを追加する

    • Press the new foot into place firmly with your finger, then apply pressure by pinching the foot from either side of the case with your finger and your thumb.

    • Maintain pressure for 30 seconds to set the pressure-sensitive adhesive.

    • Repeat the last seven steps for any remaining broken or worn feet.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Taylor Dixon

メンバー登録日: 2018年06月26日

2,816 ポイント

18のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

113 メンバー

7,342のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 12

過去 30 日: 51

今までの合計 51