はじめに

Use this guide to replace a damaged lower case.

  • Before proceeding, power down your machine. Close the display and lay it on a soft surface top-side down.

  • Remove the following ten screws:

    • Two 9 mm P5 Pentalobe screws

    • Eight 2.6 mm P5 Pentalobe screws

  • The special screwdriver needed to remove the ten 5-point Pentalobe screws can be found here.

These pentalobe screw sizes can't possibly be right - not even close. Should they perhaps be 0,8 mm and 1,2 mm?

Rulle Boer - 返信

The screw sizes refer to the length of the shaft, not the diameter of the head or socket. P5 is the standard pentalobe size for all these screws, regardless of length.

I agree that the notation is a little confusing. I think it's because, with standard sized hardware like for your house, you have shaft diameter (say 1/8" or 3mm) and shaft length (say 3" or 7.5cm). So we're programmed to think of small numbers like that as diameter. But in this case, they're length.

budpegasus - 返信

Pulling the fan cable out was terrifying but you actually just pull on the cable itself. No way to get any leverage at the connector to dislodge it. Did come out easily but like I said, scared me!

allison - 返信

Draai de schroefjes voorzichtig los en leg ze op een stabiele plek neer en let erop dat de schroefje een verschillende lengte hebben.

bwgvanderveer - 返信

I thought I could replace my 256 Gb SSD with 512? regards

ola m - 返信

Do you have good Test Point Voltages? It appears there are silver colored Test points on the I/O Board. I am working on a water spill and trying to troubleshoot if both the I/O board and the Logic need replaced.

andrew - 返信

It's probably not necessary but may be a little safer to completely discharge the old battery before replacing it.

Larry Smith - 返信

tell a model that was not inferior to the speed of the one in the laptop.

Thank you

ilyabuhov - 返信

Do i need to order tools separately to replace the battery i just ordered?

anne uhlir - 返信

im looking for a Logic Board for a

Apple - MacBook Air® - 13.3" Display - Intel Core i5 - 8GB Memory - 128GB Flash Storage (Latest Model) - Silver Model: MQD32LL/A

Any help is appreciated.

Jamie Comstock - 返信

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
  • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

  • Remove the lower case and set it aside.

There is a nub on the inside of the case which is attached to the battery. When you try to pull it open, it appears to be attached to the plastic casing of the battery, which sometimes splits. I gently unhooked the nub from the battery before removing the case fully. This seems to happen if the battery has suffered some drop damage (plastic parts broken around screws and parts of plastic frame split). Just an FYI in case your lower case doesn't pull away easily.

Jeannie Crowley - 返信

When closing this back up make sure that the antenna cable is tucked away neatly

Gabriel - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Jeff Suovanen

メンバー登録日: 2013年08月06日

166,706 ポイント

424のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

113 メンバー

6,002のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 32

過去 30 日: 94

今までの合計 7,171