メインコンテンツにスキップ

はじめに

バッテリーを交換する際にこのガイドを読んでください。

注意

薄いプラスチックフィルムが交換用のバッテリーについている場合、はがさないでください。バッテリーパックに接着されており、MacBookの中でバッテリーパックを守る役割があります。

    • 作業を始める前に、コンピュータの電源を落として下さい。ディスプレイを閉じ柔らかい表面の上に置いてください。

    • 次の10本のネジを取り外します。

    • 9mm P5 星形ペンタロープネジ 2本

    • 2.6mm P5 星形ペンタロープネジ 8本

    • 8本の星形ペンタローブネジを取り外すために必要な特殊ドライバーは、こちらです。

    Pulling the fan cable out was terrifying but you actually just pull on the cable itself. No way to get any leverage at the connector to dislodge it. Did come out easily but like I said, scared me!

    allison - 返信

    Draai de schroefjes voorzichtig los en leg ze op een stabiele plek neer en let erop dat de schroefje een verschillende lengte hebben.

    bwgvanderveer - 返信

    I thought I could replace my 256 Gb SSD with 512? regards

    ola m - 返信

    Do you have good Test Point Voltages? It appears there are silver colored Test points on the I/O Board. I am working on a water spill and trying to troubleshoot if both the I/O board and the Logic need replaced.

    andrew - 返信

    It's probably not necessary but may be a little safer to completely discharge the old battery before replacing it.

    Larry Smith - 返信

    tell a model that was not inferior to the speed of the one in the laptop.

    Thank you

    ilyabuhov - 返信

    Do i need to order tools separately to replace the battery i just ordered?

    anne uhlir - 返信

    im looking for a Logic Board for a

    Apple - MacBook Air® - 13.3" Display - Intel Core i5 - 8GB Memory - 128GB Flash Storage (Latest Model) - Silver Model: MQD32LL/A

    Any help is appreciated.

    Jamie Comstock - 返信

    P5 pentalobe screwdrivers are too big! The correct size for these screws are p4 pentalobe. P5 pentalobe was just able, with difficulty, to turn some of the screws. If the screws were at all tight, my p5 was unable to get them out, and started to strip the screws. A p4 screwdriver fit better and removed the screws with ease. (I was using high quality Wiha brand screwdrivers.)

    William Skinner - 返信

    Very simple installation. The screwdriver heads were exactly what we’re needed, one head for the outside case screws, the other for the screws holding the battery in place. The computer started right up. Now to see how the battery holds up, but I have a good feeling about this!

    Dennis Eaton - 返信

    My P5 and the T5 worked perfectly with my early 2015 Air 13”! And it is super fast! Thank you iFixit!

    Pennny Beach - 返信

    The supplied kit and instructions worked perfectly!

    Nikolay Andreev - 返信

    Comments that the P5 pentalobe are too large are absolutely spot-on. There is no way the P5 pentalobe bit I have will work with the MacBook Air without destroying the screws. Hard target search for P4 pentalobe bit in progress…..

    joemoog - 返信

    Bonjour j’aimerais changer mon SSD de 128 Go pour en mettre un de 512 Go. Je ne sais pas ce qu’il faut prendre car il faut qu’il soit compatible avec le macbook air A1466. J’aurais vu un Samsung Evo 970 500 Go mais si je ne me trompe pas, il faut un adaptateur.

    Merci pour votre aide.

    chicco33 - 返信

    oui, vous aurez besoin d’un adaptateur, pour completez le changement.

    Dan -

    The tool kit should include tweezers for re-inserting the battery connector.

    Andre Clement - 返信

  1. ディスプレイと下部ケースの間に指を入れ、上に引っ張って下部ケースを本体から外します。
    • ディスプレイと下部ケースの間に指を入れ、上に引っ張って下部ケースを本体から外します。

    • 下部ケースを取り外して脇に置きます。

    There is a nub on the inside of the case which is attached to the battery. When you try to pull it open, it appears to be attached to the plastic casing of the battery, which sometimes splits. I gently unhooked the nub from the battery before removing the case fully. This seems to happen if the battery has suffered some drop damage (plastic parts broken around screws and parts of plastic frame split). Just an FYI in case your lower case doesn't pull away easily.

    Jeannie Crowley - 返信

    When closing this back up make sure that the antenna cable is tucked away neatly

    Gabriel - 返信

  2. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  3. バッテリーコネクターに付けられている透明なプラスチックのプルタブを掴みAir本体の前側に向かって引き基盤からバッテリーを切り離します。
    • バッテリーコネクターに付けられている透明なプラスチックのプルタブを掴みAir本体の前側に向かって引き基盤からバッテリーを切り離します。

    • 切り離す際にコネクターを上方に持ち上げないで下さい。

    @&?! - pulled plastic tab on new battery to line up with logic board pins look to be coming out of male connector? Argh?!

    James Bowkett - 返信

    Can expect anyone from ifixit to get back to me?

    James Bowkett - 返信

    Hi James,

    It may be that one of the pins did not lock in properly into the plastic housing. You can try pushing the corresponding wire into the connector housing to try to lock the pin in.

    If that does not help, please respond to my email. Thanks!

    Arthur Shi -

  4. バッテリを上部ケースに固定している以下の5本のネジを外します:
    • バッテリを上部ケースに固定している以下の5本のネジを外します:

    • 6.3 mm T5トルクスねじ 3本

    • 2.4 mm T5トルクスねじ 2本

    When going in reverse, it's easier to do step 3 before 4.

    John Heffernan - 返信

  5. バッテリーを取り扱う際は、露出している4つのリチウムポリマー電池のセル部分を握ったり触ったりしないでください。
    • バッテリーを取り扱う際は、露出している4つのリチウムポリマー電池のセル部分を握ったり触ったりしないでください。

    • バッテリーをロジックボードに近い上端から持ち上げ、上部ケースから取り外します。

    • この修理ガイドを完成したら、新しく装着したバッテリーのカリブレーションを行なってください。

    • 100%になるまで充電します。充電後も最低2時間はプラグを繋げたままにします。それからプラグを外して、通常通り使用しながら、自然に放電させます。バッテリー残量小のサインが表示されたら、これまでの作業を保存して、スリープ状態になるまで放置してください。スリープ状態に入ったら、少なくとも5時間置きます。それから一気に100%まで充電します。

    • 新しいバッテリーを装着後、通常通り作動しない場合は、MacBook ProのSMCをリセットしなければならない可能性があります。

    Two Questions and a Comment:

    1) “Allow the battery to drain overnight” - Should the computer shut down automatically (during the first drain, as well)? If not, what percentage should the battery reach before charging it to 100%?

    2) While the battery is draining, can I use the computer?

    When installing the new battery, I found it much easier to insert the battery connector before screwing in the battery.

    Paul Larkin - 返信

    When reinserting the battery, plug in the battery connector before screwing the battery into place. Some wiggle room is required to reconnect the batter and tweezers will help with the plugging in.

    Andre Clement - 返信

まとめ

デバイスを再組み立てする際は、これらの手順を逆の順番に従って作業を進めてください。

174 の人々がこのガイドを完成させました。

以下の翻訳者の皆さんにお礼を申し上げます:

100%

これらの翻訳者の方々は世界を修理する私たちのサポートをしてくれています。 あなたも貢献してみませんか?
翻訳を始める ›

Walter Galan

595,087 ポイント

1,203のガイドは作成済み

USB wird nach Batterie Wechsel nicht mehr erkannt!

Stemmbrett - 返信

Easy change, thank you so much iFixit.

Jordano Moscoso - 返信

Excellent, thank you.

karlgezer - 返信

My macbook air logic board damaged but reason has not addressed by service center. They are asking to pay 700 $ and i ca not afford this much amount what is the best solutions in India . i am being &&^&@@ up buying mac book on monthly EMI. sad

Sudhir Pandey - 返信

i was disconnecting the connector from the logic board .. Do i need to exchange the whole logic board ..?

okonmaya - 返信

This was my first experience using iFixit to buy parts, tools and use the guide. I will be coming back here from now on, this guide was great and the kit arrived on time and with everything that I needed.

Devin Whitney - 返信

Perfect! You guys are the coolest…..thanks for your help….again!

mfogelquist - 返信

That was pretty easy. Just be careful when you insert the connector into the logic board socket. You’ll have to give the wires an “S” bend, then insert the connector straight in, don’t lift on it or the socket might come off the board. As you push the connector in, use your other hand to support the socket.

Maybe it would be easier to first insert the connector while the battery is sitting a little out of position, and then second pushing the battery into position.

Gregory Holmberg - 返信

Excellent guide. It took all of 15 minutes start to finish, including cleaning out the dust inside my MBA. Thanks!

Dave Gesell - 返信

I was a bit nervous before replacing the battery on my own, but following this guide made it so easy. I finished it in 12 minutes including cleaning the interior. Thank you!!

Zsolt Repasy - 返信

Great instructions. Everything seems to be working fine…minor problem was that I had to do SMC-reset because the Battery indicator showed red even though the battery was charged "100%” and OS X informed “Battery is empty and MacBook Air has to shut down”…but the problem was solved with SMC-reset. Have been using MacBook Air Middle 2013 since then (several weeks) with the new battery and everything seems to be working great. Battery was calibrated accordingly before the “red indicator 100% shut down”-thing appeared. Thank you.

Antti Alutoin - 返信

コメントを追加する

統計データを表示:

過去 24時間: 91

過去 7 日: 601

過去 30 日: 2,809

今までの合計 158,865