はじめに

Is your wireless card not working? Here's a guide to replace it. Make sure you follow each step accordingly and carefully replace the wireless card.

パーツ

パーツは必要ありません。

  1. Flip MSI GP60 2PE Leopard, so that the back is facing up.
    • Flip MSI GP60 2PE Leopard, so that the back is facing up.

  2. Find the unlock tab located on the upper right side of the device, then slide it to the right.
    • Find the unlock tab located on the upper right side of the device, then slide it to the right.

  3. Slide and hold the release tab on the left side of the battery, so that you can remove the battery. Slide and hold the release tab on the left side of the battery, so that you can remove the battery. Slide and hold the release tab on the left side of the battery, so that you can remove the battery.
    • Slide and hold the release tab on the left side of the battery, so that you can remove the battery.

  4. While holding the release tab, remove the battery slowly. While holding the release tab, remove the battery slowly. While holding the release tab, remove the battery slowly.
    • While holding the release tab, remove the battery slowly.

  5. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  6. Flip the device over so the back is facing up.
    • Flip the device over so the back is facing up.

  7. Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver. There is a screw located under the battery; lift the battery up to access it.
    • Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.

    • There is a screw located under the battery; lift the battery up to access it.

  8. Once all four screws are removed, lift the back off. Once all four screws are removed, lift the back off.
    • Once all four screws are removed, lift the back off.

  9. Locate the wireless card.
    • Locate the wireless card.

  10. Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.
    • Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.

  11. Carefully remove the wireless card.
    • Carefully remove the wireless card.

    • Pay close attention to the two wires attached to wireless card.

  12. Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them. The wires should come off fairly easily.
    • Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them.

    • The wires should come off fairly easily.

    • Avoid yanking or pulling too hard. This can result in the wires breaking.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Zoey Calcagno

メンバー登録日: 2018年10月04日

573 ポイント

5のガイドは作成済み

チーム

Linn Benton Community College, Team S1-G4, Karnes Fall 2018 Linn Benton Community College, Team S1-G4, Karnes Fall 2018人のメンバー

LBCC-KARNES-F18S1G4

4 メンバー

6のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 24

今までの合計 114