1. Use a PH1 screw driver to remove the 14 screws holding the body together.
    • Use a PH1 screw driver to remove the 14 screws holding the body together.

    • Gently pry the two halves of the case apart.

    • You will probably break off some of the clips but, the screws work fine at holding the keyboard together. aka you don't need the clips.

  2. Unscrew the one screw holding on the ground and pull out the cables. A good way of getting the cables out is by putting a screwdriver right there and twisting. Unscrew this screw
    • Unscrew the one screw holding on the ground and pull out the cables.

    • A good way of getting the cables out is by putting a screwdriver right there and twisting.

    • Unscrew this screw

  3. Free shipping on all orders over $100.00 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する

    今まで、何かを修理したことがありますか?ジーニアスです。

    あなたのリペアストーリーを#ImAGenius でシェアしてください。

    私たちは皆んな、ジーニアスです。

    あなたのリペアストーリーを#ImAGenius でシェアしてください。

  4. The light thing comes out with a wiggle.
    • The light thing comes out with a wiggle.

    • The scroll wheel on the other is harder because you have to melt or brake the supports off.

    • Then you have to get the wheel out which comes out with a very gentle wiggle.

  5. You can then take off the little pads
    • You can then take off the little pads

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

thefluffyfist

メンバー登録日: 2017年04月08日

387 ポイント

2のガイドは作成済み

統計データを表示:

過去 24時間: 2

過去 7 日: 18

過去 30 日: 80

今までの合計 266