Logitech Dual Action Triggers Repair

手順1 Logitech Dual Action Triggers Repair

Logitech Dual Action Triggers Repair, Logitech Dual Action Triggers Repair: 手順 1、 1の画像 1

To get into the controller, you will need to unscrew the 7 screws on the back.
You will have to remove the bottom oval sticker to reveal the screw circled in red.

編集

手順2

Logitech Dual Action Triggers Repair: 手順 2、 2の画像 1

Logitech Dual Action Triggers Repair: 手順 2、 2の画像 2

With the screws removed, turn the controller upside down and separate the front end from the back end.
It is likely that the buttons will fall out of place, so as you open the controller, try to keep track of where the pieces go.

編集

手順3

Logitech Dual Action Triggers Repair: 手順 3、 1の画像 1

There should be 4 circular buttons labeled 1-4, 4 smaller circular buttons for the D-Pad, and 3 oval shaped buttons.

編集

手順4

Logitech Dual Action Triggers Repair: 手順 4、 3の画像 1

Logitech Dual Action Triggers Repair: 手順 4、 3の画像 2

Logitech Dual Action Triggers Repair: 手順 4、 3の画像 3

In the center of the controller, pull upwards on the USB cord.
Be careful not to pull hard enough to yank the wires connecting to the logic board.
With the wire out of the way, remove the screw it exposed. This will disconnect the logic board from the controller.

編集

手順5

Logitech Dual Action Triggers Repair: 手順 5、 3の画像 1

Logitech Dual Action Triggers Repair: 手順 5、 3の画像 2

Logitech Dual Action Triggers Repair: 手順 5、 3の画像 3

To remove the triggers, push upwards from the back on them.
Once far enough, detach the logic board from the back cover piece and the triggers.

編集

手順6

Logitech Dual Action Triggers Repair: 手順 6、 2の画像 1

Logitech Dual Action Triggers Repair: 手順 6、 2の画像 2

If the wire is unplugged solely from the logic board, you can fasten it back into its place.
Look at the second picture to see where the wires go.

編集

手順7

Logitech Dual Action Triggers Repair: 手順 7、 3の画像 1

Logitech Dual Action Triggers Repair: 手順 7、 3の画像 2

Logitech Dual Action Triggers Repair: 手順 7、 3の画像 3

Unscrew the screw on the trigger to remove the back cover.
Once removed, carefully pull the back cover off.

編集

手順8

Logitech Dual Action Triggers Repair: 手順 8、 1の画像 1

The 3 wires are soldered into the 3 spots circled on the picture.
You can now fasten the wire into the right spot on the trigger piece.