1. Remove the button with the arrow pointing left.
    • Remove the button with the arrow pointing left.

    • You can do this by putting your fingernail or a Spudger underneath the button and pulling up.

  2. Remove the two 10mm screws with a Phillips head screwdriver using the #00 bit.
    • Remove the two 10mm screws with a Phillips head screwdriver using the #00 bit.

    • Use a plastic Spudger to pry open and disconnect the screen from the rest of the tablet.

    • Be gentle and work from the bottom of the tablet counterclockwise.

    • Open the tablet screen to the left. Making sure not to disconnect any of the wires connecting the screen and tablet.

    • Disconnect the ribbon connector by pulling up on the white gate.

    • Then just simply pull the wire to the left disconnecting it.

    • Disconnect the ribbon connector by opening the white gate.

    • Then just simply pull up on the wire to disconnect it.

    • Finally Disconnect the last ribbon connector.

    • You can do this by using your fingernails to grip the ends of the connector and simply pulling gently to the left.

    • There might be some tape over the connector that you will have to remove.

    • You have successfully removed the old screen(the part on the left).

まとめ

To reassemble your device, follow these instructions in reverse order.

Michael Gaskey

メンバー登録日: 2018年09月28日

337 ポイント

2のガイドは作成済み

チーム

University of North Texas, Team S1-G2, Riccardelli Fall 2018 University of North Texas, Team S1-G2, Riccardelli Fall 2018人のメンバー

UNT-RICCARDELLI-F18S1G2

4 メンバー

5のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 34

今までの合計 41