はじめに

If the laser is not turning on, or flickering, the problem may be caused by a faulty leaf spring. In order to replace this part, follow the steps in this guide.

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
  • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

  • Remove the battery door and take the batteries out.

コメントを追加する

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside. Lift the side of the blaster off exposing its internal parts. Lift the side of the blaster off exposing its internal parts.
  • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

  • Lift the side of the blaster off exposing its internal parts.

コメントを追加する

Work the trigger to ensure the problem is the switch not making a proper connection.
  • Work the trigger to ensure the problem is the switch not making a proper connection.

  • Remove the retaining phillips head 10.2 mm screw below the switch.

コメントを追加する

Use a hot soldering iron to melt the solder of the two wires at the rear of the switch.  Take note that the red wire leads from the top of the switch.
  • Use a hot soldering iron to melt the solder of the two wires at the rear of the switch. Take note that the red wire leads from the top of the switch.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Jeffrey Sargeant

メンバー登録日: 2014年02月24日

258 ポイント

1ガイドが承認済み

チーム

Michigan Tech, Team 5-8, Lauer Spring 2014 Michigan Tech, Team 5-8, Lauer Spring 2014人のメンバー

MTU-LAUER-S14S5G8

3 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 14

今までの合計 991