Le Pan S Volume Rocker Replacement

はじめに

First, check to see if the volume is turned up to a reasonable level by using both the volume rocker on the side of the device and the digital volume bar in the settings menu. If the troubleshooting has not solved the issue, the volume rocker will need to be replaced in a few simple steps. Minimal tools will be needed for this guide.

必要な工具と部品

手順1 Battery

Le Pan S Volume Rocker Replacement, Battery: 手順 1、 1の画像 1

Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.
This cover is adjacent to the volume button on the side of the Le Pan S.

編集

手順2

Insert the spudger between the front and back panel in order to pry them apart.
Do this beside the volume button and the micro SD cover.
Pry open the rest of the Le Pan S by dragging the spudger across the side.

編集

手順3

Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

編集

手順4

Disconnect the battery from the circuitry and lay it out of the way.
The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.
If you are replacing your battery, make sure to dispose of it properly.