はじめに

Also look at the LG Versa VX9600 Teardown for help disassembling your phone.

  1. Insert wisdom here.
    • Insert wisdom here.

    コメントを追加する

  2. LG Versa has a 3" touchscreen with a call, power, and clr button on the front.
    • LG Versa has a 3" touchscreen with a call, power, and clr button on the front.

    • On left side you will find the volume control buttons and camera button. Also, the charger port.

    • On the other side you will find the microSD or microSDHC slot.

    コメントを追加する

    • The LG Versa has a 2.0 megapixel camera with a LED flash on the back

    コメントを追加する

    • On the right hand side of the LG Versa there is a latch to open up the back of the cell phone. Push the latch up and lift off the back of the phone exposing the battery.

    コメントを追加する

    • Simply insert your finger in between the slot and the battery and push down and up to remove the battery.

    コメントを追加する

    • Six Phillips screws holding down the battery housing (Circled in the picture). Unscrew the six screws and put them aside.

    コメントを追加する

    • Insert a safe prying tool between the slot between the front screen housing and the battery housing to remove the battery housing.

    コメントを追加する

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • In the bottom right corner of the logic board, disconnect the button connector with tweezers or a prying tool.

    コメントを追加する

    • Use a prying tool to safely lift up the logic board from the logic board housing

    • The logic board is connected to the speaker and the LCD screen from the back. Do not lift the logic board too high or you will have to replace the LCD screen and the speaker.

    コメントを追加する

    • The LCD screen is connected to the bottom of the logic board. Once you lift the logic board use tweezers or a safe prying tool to disconnect the ribbon wire from the LCD screen to the logic board.

    コメントを追加する

    • Lift the logic board carefully and use a safe prying tool and tweezers to remove the speaker.

    • The speaker is attached to the housing with a rubber adhesive be careful not to rip the wire from the logic board and the speak apart

    コメントを追加する

    • In the top right corner of the housing use a pry tool to disconnect the touch screen digitizer connector from the housing.

    コメントを追加する

    • Removing the logic board housing from the front housing is the most difficult part of the tear down.

    • Start on the side with the volume control buttons and use a safe pry tool to separate both housings.

    コメントを追加する

    • Use the safe pry tool around the perimeter of the phone until you are able to separate both housing apart.

    • Remove the Lock, Volume, and Front buttons from the housing.

    コメントを追加する

    • Simply lift the LCD screen from the logic board housing to remove the LCD screen.

    コメントを追加する

    • Congratulations you have fully torn down the LG Versa.

    コメントを追加する

    • Use a safe prying tool and pry around the perimeter until the screen is separated from the housing.

    コメントを追加する

    • Using your thumbs, push the glass screen off the housing and pull the screen off.

    • Be carful to not rip the ribbon cable while taking the screen off. There is a hole in the top left corner of the housing where the ribbon cable should be pulled out.

    コメントを追加する

    • Apply super glue around the edge of the housing where the class will sit.

    コメントを追加する

    • Put the ribbon cable through the hold and place your new touch screen inside the housing.

    コメントを追加する

    • Push the housing and the glass together. Wait 5-10 minutes for glue to dry.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Stefan Yap

メンバー登録日: 2011年03月03日

29 ポイント

3のガイドは作成済み

チーム

University of Maryland, Team 1-1, Calloway Spring 2011 University of Maryland, Team 1-1, Calloway Spring 2011人のメンバー

UMD-CALLOWAY-S11S1G1

2 メンバー

3のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 2

今までの合計 6,400