はじめに

Phone won't charge, and the charger is functional? Replace your phone's charging adapter.

NOTE: Charging adapter is attached to the logic board, so replacement requires replacing the logic board.

パーツ

パーツは必要ありません。

  1. Lay the phone face down with the screen in palm of hand.
    • Lay the phone face down with the screen in palm of hand.

    • Slide the grey button towards the top of the phone.

    コメントを追加する

  2. While the button is slid up grab the battery on the sides and pull up with the bottom remaining in place.
    • While the button is slid up grab the battery on the sides and pull up with the bottom remaining in place.

    • Pull the battery up vertically to completely remove from phone.

    コメントを追加する

    • Remove four screws beneath battery using screw driver.

    • Remove three rubber screw covers with tweezers.

    • Remove the three screws under the covers with the screwdriver.

    コメントを追加する

    • Detach outer casing from back of phone.

    • NOTE: There will be a significant amount of resistance to detaching the back casing.

    コメントを追加する

    • Unsnap gold rectangular plate and silver square plate from the logic board.

    コメントを追加する

    • Remove logic board, being careful not to remove any other pieces.

    • Insert new logic board with white side facing down.

    • NOTE: Make sure side buttons on logic board are correctly aligned to avoid future complications.

    コメントを追加する

    • Replace logic board to replace charging adapter.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Nichole Shaw

メンバー登録日: 2010年04月13日

1 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 18-75, Johann Spring 2010 Cal Poly, Team 18-75, Johann Spring 2010人のメンバー

CPSU-JOHANN-S10S18G75

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 2,363