はじめに

Repairing the logic board.

Turn the closed phone so that the back panel is facing you.
  • Turn the closed phone so that the back panel is facing you.

  • Press down and forward firmly on the gray tab in the middle of the phone.

コメントを追加する

Now just lift up on the battery and remove it from the phone. Now just lift up on the battery and remove it from the phone.
  • Now just lift up on the battery and remove it from the phone.

コメントを追加する

Remove the rubber grommet using a Spudger.
  • Remove the rubber grommet using a Spudger.

コメントを追加する

Be sure not to lose the screws. They are small!
  • Be sure not to lose the screws. They are small!

  • Remove the five screws using a Phillips #00 Screwdriver.

コメントを追加する

When removing back cover, be careful not to break the speaker wires. Using an iPod Opening Tool, carefully pry off the back cover. Using Tweezers, gently pull speaker wires out.
  • When removing back cover, be careful not to break the speaker wires.

  • Using an iPod Opening Tool, carefully pry off the back cover.

  • Using Tweezers, gently pull speaker wires out.

コメントを追加する

Separate the two halves.
  • Separate the two halves.

コメントを追加する

Carefully pry and lift up on the logic board using an iPod Opening Tool. Carefully pry and lift up on the logic board using an iPod Opening Tool. Carefully pry and lift up on the logic board using an iPod Opening Tool.
  • Carefully pry and lift up on the logic board using an iPod Opening Tool.

コメントを追加する

Carefully flip the logic board up and out of the way.
  • Carefully flip the logic board up and out of the way.

コメントを追加する

Use an iPod Opening Tool to lift up on the keypad and pull it out. Use an iPod Opening Tool to lift up on the keypad and pull it out. Use an iPod Opening Tool to lift up on the keypad and pull it out.
  • Use an iPod Opening Tool to lift up on the keypad and pull it out.

コメントを追加する

DO NOT TOUCH SOLDERING IRON. IT IS EXTREMELY HOT.
  • DO NOT TOUCH SOLDERING IRON. IT IS EXTREMELY HOT.

  • De-solder solder joint on front using Soldering Iron.

コメントを追加する

De-solder solder joint on the back using Soldering Iron.
  • De-solder solder joint on the back using Soldering Iron.

コメントを追加する

Carefully detach ribbon cable and remove logic board. Carefully detach ribbon cable and remove logic board. Carefully detach ribbon cable and remove logic board.
  • Carefully detach ribbon cable and remove logic board.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

David Foster

メンバー登録日: 2010年04月11日

1 ポイント

16のガイドは作成済み

チーム

Cal Poly, Team 25-88, Amido Spring 2010 Cal Poly, Team 25-88, Amido Spring 2010人のメンバー

CPSU-AMIDO-S10S25G88

4 メンバー

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 1

今までの合計 1,455