はじめに

This guide will help you through the process of replacing the LG Muziq's keypad.

Slide the battery cover release towards top of phone.
  • Slide the battery cover release towards top of phone.

  • Place one finger at each side of the battery cover.

  • Lift and remove the battery cover.

コメントを追加する

Place a finger at the top corner of the battery and lift out of the phone.
  • Place a finger at the top corner of the battery and lift out of the phone.

コメントを追加する

  • Use the spudger to lift up the two screw covers at the top of the phone.

  • Remove all four Phillips#00 (3.3mm) screws with screwdriver.

コメントを追加する

  • Use the spudger to lift up the rear case from the phone.

  • Note: Rear case is connected on all sides and will have to be detached on all sides before removal.

  • Remove the rear case from the device.

コメントを追加する

  • Use the spudger to lift the motherboard from the phone.

コメントを追加する

  • Caution: The circuit board is connected via ribbon to the phone. Do not break this connection.

  • Note: The circuit board is attached by clips on both sides of the board. Detach each clip before removing the motherboard from the phone.

  • Use the spudger to detach the circuit board from the phone.

コメントを追加する

  • Open the phone to expose the keypad.

  • Use your finger to push the keypad from the front towards the circuit board.

  • Remove the keypad from the phone.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Braden Burk

メンバー登録日: 2012年01月22日

1 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 3-29, Amido Winter 2012 Cal Poly, Team 3-29, Amido Winter 2012人のメンバー

CPSU-AMIDO-W12S3G29

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 636