Use a spudger to remove the two screw covers below display. Use a screw driver to remove the four Phillips #00 (3.3mm) screws at corners of the display.
  • Use a spudger to remove the two screw covers below display.

  • Use a screw driver to remove the four Phillips #00 (3.3mm) screws at corners of the display.

コメントを追加する

Caution: Wires and ribbon connect the front case to the main body. Exhibit care when separating front case from the main body as to not break the connections. Note: Side buttons may fall out when removing the front case. Do not misplace them. Note: Each side button will only fit in the side that it came from.
  • Caution: Wires and ribbon connect the front case to the main body. Exhibit care when separating front case from the main body as to not break the connections.

  • Note: Side buttons may fall out when removing the front case. Do not misplace them.

  • Note: Each side button will only fit in the side that it came from.

  • Insert a spudger between the black and grey casings and gently spread them apart.

  • Work around the device gradually, opening the gap further.

コメントを追加する

Caution: The wires and ribbon connector can break easily. Exhibit care when removing them. Use the spudger and lift upward to disconnect the ribbon from the main part of the phone. Carefully remove any parts stuck to the front case such as speakers.
  • Caution: The wires and ribbon connector can break easily. Exhibit care when removing them.

  • Use the spudger and lift upward to disconnect the ribbon from the main part of the phone.

  • Carefully remove any parts stuck to the front case such as speakers.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Raymond Ching

メンバー登録日: 2012年01月19日

1 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-29, Amido Winter 2012 Cal Poly, Team 3-29, Amido Winter 2012人のメンバー

CPSU-AMIDO-W12S3G29

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 514