はじめに

This guide will assist you in replacing your phone's faulty camera.

Use a spudger to remove the two screw covers below display.
  • Use a spudger to remove the two screw covers below display.

  • Use a screw driver to remove the four Phillips #00 (3.3mm) screws at corners of the display.

コメントを追加する

Caution: Wires and ribbon connect the front case to the main body. Exhibit care when separating front case from the main body as to not break the connections.
  • Caution: Wires and ribbon connect the front case to the main body. Exhibit care when separating front case from the main body as to not break the connections.

  • Note: Side buttons may fall out when removing the front case. Do not misplace them.

  • Note: Each side button will only fit in the side that it came from.

  • Insert a spudger between the black and grey casings and gently spread them apart.

  • Work around the device gradually, opening the gap further.

コメントを追加する

  • Caution: The wires and ribbon connector can break easily. Exhibit care when removing them.

  • Use the spudger and lift upward to disconnect the ribbon from the main part of the phone.

  • Carefully remove any parts stuck to the front case such as speakers.

コメントを追加する

  • Disconnect the ribbons on both sides of the camera by prying them up with a spudger.

コメントを追加する

  • Hold the wiring out of the way and pull up with a spudger behind the camera.

  • The camera unit should come unglued and separate from the phone.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Braden Burk

メンバー登録日: 2012年01月22日

1 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 3-29, Amido Winter 2012 Cal Poly, Team 3-29, Amido Winter 2012人のメンバー

CPSU-AMIDO-W12S3G29

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 638