はじめに

The circuit board and full key board are attached and must be installed together as one unit. Do not try to separate them.

Place the phone so the screen side is facing down.
  • Place the phone so the screen side is facing down.

  • Locate the latch at the end of the phone, opposite of the camera.

コメントを追加する

Push/pull the latch away from the camera, causing the battery to pop out.
  • Push/pull the latch away from the camera, causing the battery to pop out.

コメントを追加する

  • Remove the battery.

コメントを追加する

  • Remove the 5 screw covers on the back of the phone using a Push Pin.

コメントを追加する

  • With a Phillips #00 Screwdriver, remove the five 3.44 mm screws that were under the screw covers.

  • Also with a Phillips #00 Screwdriver, remove the screw that was revealed once the battery was removed.

コメントを追加する

  • Open the phone.

コメントを追加する

  • Starting at the card slot or charger port for greater ease, pry off the colored casing from the back of the phone using the Plastic Pry Tool (or a finger nail may work).

  • Prying open the part just to the left of the right hinge can be difficult.

  • Remove the back colored casing and set it to the side.

コメントを追加する

  • Gently pry and detach the connection located near the hinge with fingers.

コメントを追加する

  • The circuit board and the key board will be attached, as shown in the second picture.

  • Lift them both out from the rest of the phone.

  • Do not try to the detach key board pad from the circuit board. They are replaced as a unit.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Stephanie Villavicencio

メンバー登録日: 2012年04月05日

16 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 15-15, Forte Spring 2012 Cal Poly, Team 15-15, Forte Spring 2012人のメンバー

CPSU-FORTE-S12S15G15

5 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,080