メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

  1. Use a Spudger to remove the two front plastic covers to reveal screws. Use a Spudger to remove the two front plastic covers to reveal screws.
    • Use a Spudger to remove the two front plastic covers to reveal screws.

  2. Remove two screws using a Torx T6 screwdriver.
    • Remove two screws using a Torx T6 screwdriver.

  3. Pry off the screen front cover with a small flathead screwdriver. Pry off the screen front cover with a small flathead screwdriver.
    • Pry off the screen front cover with a small flathead screwdriver.

  4. Insert a small flathead screwdriver into the hinge and separate hinge connection.
    • Insert a small flathead screwdriver into the hinge and separate hinge connection.

  5. Pry off the speaker which is glued on to the front cover using a small flathead screwdriver.
    • Pry off the speaker which is glued on to the front cover using a small flathead screwdriver.

  6. Remove remaining portion of the front case from the flexible circuit board.
    • Remove remaining portion of the front case from the flexible circuit board.

    • Do not attempt to remove the LCD board at this time, as it is attached to the rear panel assembly.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Nicholas Schmidt

メンバー登録日: 2010年10月09日

97 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 3-25, Regan Fall 2010 Cal Poly, Team 3-25, Regan Fall 2010人のメンバー

CPSU-REGAN-F10S3G25

4 メンバー

14のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 918