はじめに

Use this guide to disassemble a Kodak EasyShare CD82, in order to remove and replace the LCD display screen.

Remove the batteries and the memory card from the device.
  • Remove the batteries and the memory card from the device.

  • Remove the 2 screws located at the bottom of the device.

コメントを追加する

Remove the 2 screws on the side, to the left of the camera lens.
  • Remove the 2 screws on the side, to the left of the camera lens.

  • Remove the 2 screws on the side, to the right of the camera lens.

  • Pry the casing from the device starting at the battery compartment and following the seem around the camera.

コメントを追加する

  • Remove the front panel from the device first, then remove the back panel.

  • Do not remove the LCD screen from the device once it becomes visible.

コメントを追加する

  • Flip the LCD screen away from the top of the device to reveal the ribbon cable.

    • This is water damage the has afflicted the camera.

  • Remove the 3 screws from the LCD screen holder.

  • Pry the screen holder from the circuit board connector.

コメントを追加する

  • Disconnect the logic board from the right side of the frame.

    • Remove the small ribbon cable that is connecting the button panel to the logic board, using a small pair of tweezers or hemostat.

    • Remove the screw on the top right side of the device.

コメントを追加する

  • Open the connector and move the black clip into the upward position, freeing the cable. Remove the LCD screen and the holder.

    • While the camera is disassembled, use isopropyl alcohol to remove rust and clean the device.

  • Follow these steps in reverse order to reassemble. The device should be fully functional upon completion.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

oldturkey03

メンバー登録日: 2010年09月29日

531,276 ポイント

101のガイドは作成済み

チーム

OTS OTS人のメンバー

Business

1 メンバー

121のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,107