メインコンテンツにスキップ

パーツ

パーツは指定されていません。

  1. Use the flat end of a spudger to peel the ambient light sensor cable off of the frame. You will need to peel up the silver tape in the cable's lower right bend. The silver tape under the lower left bend of the cable does not need to come up with it. You will need to peel up the silver tape in the cable's lower right bend. The silver tape under the lower left bend of the cable does not need to come up with it.
    • Use the flat end of a spudger to peel the ambient light sensor cable off of the frame.

    • You will need to peel up the silver tape in the cable's lower right bend. The silver tape under the lower left bend of the cable does not need to come up with it.

  2. Use the flat end of a spudger to peel up the silver tape securing the antenna cable.
    • Use the flat end of a spudger to peel up the silver tape securing the antenna cable.

  3. Remove the five 3.6 mm Phillips #00 screws securing the frame and ambient light sensor.
    • Remove the five 3.6 mm Phillips #00 screws securing the frame and ambient light sensor.

終わりに

To reassemble your device, follow these instructions in reverse order.

Phillip Takahashi

メンバー登録日: 2011年08月22日

78,416 ポイント

87のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 522