KidzLane Walkie-Talkie Press-to-speak button Replacement - iFixit 修理ガイド

はじめに

You will need a small Phillips head screwdriver and a soldering device to complete this project.

必要な工具と部品

手順1 Press-to-speak button

KidzLane Walkie-Talkie Press-to-speak button Replacement, Press-to-speak button: 手順 1、 1の画像 1

Place the Walkie-Talkie on a flat surface-preferably a table or a desk.
Flip the device over to where you see four screws in each corner.
Make sure you take out the batteries before proceeding.

手順2

KidzLane Walkie-Talkie Press-to-speak button Replacement: 手順 2、 2の画像 1

KidzLane Walkie-Talkie Press-to-speak button Replacement: 手順 2、 2の画像 2

Using your Phillips head screwdriver, unscrew all four 4mm screws from each corner.

手順3

KidzLane Walkie-Talkie Press-to-speak button Replacement: 手順 3、 1の画像 1

Once you have unscrewed all four corners, open the device so it will be in two parts.
As you're opening the inside of the Walkie-Talkie, don't break off any wires within the device.
Taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).
Separate these screws from the other four since they are different sizes.

手順4

KidzLane Walkie-Talkie Press-to-speak button Replacement: 手順 4、 2の画像 1

KidzLane Walkie-Talkie Press-to-speak button Replacement: 手順 4、 2の画像 2

Take the circuit board out of the plastic casing.
Use the soldering device to iron the silver box (press-to-speak button), and then remove it from the circuit board.

ゴール

2 の人々がこのガイドを完成させました。

作成者

7人の作成者と共同で作成されました。

Amin

メンバー登録日: 02/13/16

642 ポイント

5のガイドは作成済み

+4 個以上のバッジ

チーム

IUPUI, Team 1-1, Wilson Spring 2016 IUPUI, Team 1-1, Wilson Spring 2016人のメンバー

IUPUI-WILSON-S16S1G1

4 メンバー

5のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 5

今までの合計 898