Kid Galaxy Morphibians Explorer On/Off Switch Replacement

はじめに

Before starting your repair, remove the battery to take away all risk of electrical shock. While taking apart the Kid Galaxy Morphibian Explorer there are many small moving parts that are easily broken, so be cautious when removing components. There are many wires once you have removed the outer cover of the Kid Galaxy Explorer, so be aware of which wires are being removed and where they will be put back.

必要な工具と部品

手順1 Remove the Top Cover

Kid Galaxy Morphibians Explorer On/Off Switch Replacement, Remove the Top Cover: 手順 1、 1の画像 1

First, completely loosen the 9.6 mm Phillips #2 screw on top. There is a plastic washer that holds the screw to the top cover, so it will not need to be taken out.

編集

手順2

After the screw has been loosened, lift the cover off.

編集

手順3

Completely loosen the 9.6 mm Phillips #2 screw from the battery cover. Once again, there is a plastic washer to hold the screw to the cover.

編集

手順4

After the screw is loosened, lift the battery cover off the top cover to gain access to the batteries.
Turn the RC car over to reach the six screws on the bottom.

編集

手順5

Remove the six 11.6 mm Phillips #2 screws on the bottom cover.
(Wheels are removed in this picture to clearly show screw location. They do not need to be removed for this step)

編集

手順6

Lift the top Cover off the car.

編集

手順7 On/Off Switch

Kid Galaxy Morphibians Explorer On/Off Switch Replacement, On/Off Switch: 手順 7、 1の画像 1

On the top of the inside cover you will see the back side of the on/off switch. Remove the two 7.2 mm Philips #00 head screws holding the switch in place.

編集

手順8

Gently pull the on/off switch off the inside cover.
Remove the positive (red wire) and negative (black wire) terminals from the bottom of the batter cover. Snip the wires using wire cutters.
Remove to freed on/off switch from the inside cover.