メインコンテンツにスキップ

Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement

必要な工具と部品

  1. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement, Batteries: 手順 1、 1の画像 1
    • Turn the controller over to the backside and locate the battery cover screw.

  2. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 2、 1の画像 1
    • The battery cover 8.0mm Phillips #2 screw is on the bottom left handle. There is a plastic washer holding the screw to the cover, so completely loosen the screw, but do not remove.

  3. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 3、 1の画像 1
    • Once the screw is removed lift the battery cover up from the controller.

  4. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 4、 1の画像 1
    • Remove the 2 AA batteries.

  5. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement, Internal Chip: 手順 5、 1の画像 1
    • Remove both 6.0mm Phillips #1 screws holding the D-pads in place.

  6. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 6、 1の画像 1
    • Insert wisdom here.

  7. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 7、 1の画像 1
    • Remove the six 8.1 Phillips #1 screws.

  8. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 8、 1の画像 1
    • Lift the antenna holder away from the controller towards the top of the antenna.

  9. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 9、 1の画像 1
    • Before you separate both halves of the controller make sure the battery holder is facing you so the D-pads stay in place.

    • Separate both halves of the controller.

  10. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 10、 1の画像 1
    • Remove the 7.9 Phillips #1 screw that holds both the antenna and the internal chip.

  11. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: 手順 11、 1の画像 1
    • Remove the internal chip by pulling it away from the controller.

    • Remove both the positive(red wire) and negative(black wire) from the battery terminals.

    • Reverse the steps to put everything back together.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

7人の作成者と共同で作成されました。

Rusbell Gonzalez

メンバー登録日: 09/17/14

219 ポイント

5のガイドは作成済み

チーム

USF Tampa, Team 1-2, Hickman Fall 2014 USF Tampa, Team 1-2, Hickman Fall 2014人のメンバー

USFT-HICKMAN-F14S1G2

3 メンバー

7のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 177