JBL Everest Elite 300 Headband Cushion Replacement

はじめに

If the headband of your headphones displays signs of wear and tear or provides discomfort, then this guide is perfect for you. This guide will help you easily remove and replace the headband. All you need is a Phillips #000 screwdriver, an iFixit opening pick, and a SIM card ejector.

必要な工具と部品

手順1 Headband Cushion

JBL Everest Elite 300 Headband Cushion Replacement, Headband Cushion: 手順 1、 1の画像 1

Extend the headphone.

編集

手順2

JBL Everest Elite 300 Headband Cushion Replacement: 手順 2、 3の画像 3

Bend the hinge slightly, then remove the two .5 mm screws with a Phillips #000 screwdriver.
This will be repeated on both sides.

編集

手順3

Slide down the "Elite 300" tab.
Repeat on both sides.

編集

手順4

Use a SIM tool to push pin fully through and out.
Repeat on the other side.

編集

手順5

Go along the edges with the pick, and pull up, taking off the band.

編集

手順6

JBL Everest Elite 300 Headband Cushion Replacement: 手順 6、 3の画像 3

After fully taking off the band, you are now ready to insert in the new band.
When placing in the new headband, line up the holes as shown in image 2.
The headband is difficult to replace, however after lining up the holes, the headband will snap into place. Push into the plastic and push away from you. A click will happen indicating it attatching.