修理を始めるには コミュニティ ストア

Ion Air Pro Body Cover Replacement

はじめに

This step is one of the longest steps to complete yet it is essential in order to replace the body cover. If the Ion Air Pro is unable to be mounted on because the body cover is damaged, the body cover will have to be replaced. Follow these steps carefully on how to remove the body cover.

必要な工具と部品

  1. Ion Air Pro Body Cover Replacement, Body Cover: 手順 1、 1の画像 1

    • Unscrew all six screws.

    • Make sure you put the screws in a good spot where you won't lose them because they are small.

    編集

  2. Ion Air Pro Body Cover Replacement: 手順 2、 1の画像 1

    • After you're done with unscrewing, take off the blue lid shown here.

    編集

  3. Ion Air Pro Body Cover Replacement: 手順 3、 1の画像 1

    • On the other side of the device, lift this black piece of cover that is underneath the cap, on the bottom side of the Ion Air Pro.

    編集

  5. Ion Air Pro Body Cover Replacement: 手順 4、 1の画像 1

    • After removing the black lid, unscrew all eight screws here.

    • Again, make sure you keep track of your screws and don't lose them.

    編集

  6. Ion Air Pro Body Cover Replacement: 手順 5、 1の画像 1

    • Remove two more screws, one on each side, inside this socket.

    編集

  7. Ion Air Pro Body Cover Replacement: 手順 6、 1の画像 1

    • Next, unscrew the two screws located here.

    編集

  8. Ion Air Pro Body Cover Replacement: 手順 7、 1の画像 1

    • Detach the bottom black piece off from the bottom side but do not disconnect it from the wires.

    • Everything inside is still connected with all the wires, so be careful not to pull too hard or else everything inside could fall out or get broken.

    編集

  9. Ion Air Pro Body Cover Replacement: 手順 8、 1の画像 1

    • Finally, you can remove the body cover off and replace it with a new one if you have to.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

作成者

5人の作成者と共同で作成されました。

Christopher Brandl

メンバー登録日: 10/09/18

673 ポイント

5のガイドは作成済み

バッジ: 9

+6 個以上のバッジ

チーム

UW Stout, Team S6-G2, Ogden Fall 2018 UW Stout, Team S6-G2, Ogden Fall 2018人のメンバー

UWSTOUT-OGDEN-F18S6G2

4 メンバー

5のガイドは作成済み

4 件のコメント

Hey Chris where can I buy a replacement body cover?

The thread of the screw socket on my ion air pro WiFi has worn out and it can no longer be screwed onto any mounts.

Sam s - 返信

I LOST THE LOSTTHE REAR COVER WHILE HUNTING. iS THERE A REPLACEMENT I CAN GET

mcbee1010 - 返信

i lost the rear cover cap while hunting. can i purchase a new one

mcbee1010 - 返信

Can you show a photo of the other side (compared to step 8) showing the mounting thread please?

Andrew Mawby - 返信

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 6

今までの合計 628