はじめに

This guide details the steps to take off the button pad of your Inter-tel IP 8660.

パーツ

パーツは必要ありません。

  1. Before disassembling the phone, make sure it is not plugged into power and the handset phone cord is disconnected from the handset jack.
    • Before disassembling the phone, make sure it is not plugged into power and the handset phone cord is disconnected from the handset jack.

  2. Unscrew the 9 highlighted screws using a #1 Phillips head screwdriver. You can use a magnetized screwdriver to draw them out. 8 mm long 11 mm long
    • Unscrew the 9 highlighted screws using a #1 Phillips head screwdriver. You can use a magnetized screwdriver to draw them out.

    • 8 mm long

    • 11 mm long

  3. Lift up the back cover and set it aside.
    • Lift up the back cover and set it aside.

  4. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  5. While holding down the motherboard, gently pull the wire harness connecting the speaker to the motherboard until it comes free.
    • While holding down the motherboard, gently pull the wire harness connecting the speaker to the motherboard until it comes free.

  6. Lift up the speaker.
    • Lift up the speaker.

  7. Lift up the motherboard and set aside
    • Lift up the motherboard and set aside

  8. Peel off all rubber button covers.
    • Peel off all rubber button covers.

  9. Remove all plastic buttons.  (Note: Look at the initial picture for locations of each button set)
    • Remove all plastic buttons. (Note: Look at the initial picture for locations of each button set)

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Juan David GutierrezFranco

メンバー登録日: 2012年01月20日

67 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 11-24, Maness Winter 2012 Cal Poly, Team 11-24, Maness Winter 2012人のメンバー

CPSU-MANESS-W12S11G24

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 677