メインコンテンツにスキップ

Insignia NSD9PDVD15 Screen Replacement

必要な工具と部品

  1. Insignia NSD9PDVD15 Screen Replacement, Screen: 手順 1、 2の画像 1 Insignia NSD9PDVD15 Screen Replacement, Screen: 手順 1、 2の画像 2
    • Slide the “Open” tab on the top of the device.

    • This will allow you to open the device.

  2. Insignia NSD9PDVD15 Screen Replacement: 手順 2、 1の画像 1
    • Remove the six Phillips #00 screws from the screen casing.

    • To access two of the screws, first remove 2 small, flat rubber circles from the corners of the screen casing. Use a spudger if necessary.

  3. Insignia NSD9PDVD15 Screen Replacement: 手順 3、 1の画像 1
    • Remove the two screws from the hinge that holds together the screen casing and the disk panel.

    • Abruptly opening the device too wide will break the hinge. To fully access the hinge screws, firmly but gently open the device wider.

  4. Insignia NSD9PDVD15 Screen Replacement: 手順 4、 1の画像 1
    • Insert the plastic opening tool into the rectangular holes and pry open in order to access the interior of the screen casing.

    • Remove the four screws and corresponding washers from the edges of the screen.

    • Use a plastic opening tool to prop open if necessary.

  5. Insignia NSD9PDVD15 Screen Replacement: 手順 5、 1の画像 1
    • Remove the eight screws from the green motherboard.

  6. Insignia NSD9PDVD15 Screen Replacement: 手順 6、 1の画像 1
    • Unplug the red wires from the motherboard by gently pulling them off.

    • Then remove the screen.

  7. Insignia NSD9PDVD15 Screen Replacement: 手順 7、 1の画像 1
    • Set the new screen in place.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

8人の作成者と共同で作成されました。

Jen Rodas

メンバー登録日: 09/30/15

1 ポイント

1ガイドが承認済み

チーム

Ohio State, Team 2-5, Garvin Fall 2015 Ohio State, Team 2-5, Garvin Fall 2015人のメンバー

OSU-GARVIN-F15S2G5

3 メンバー

1のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 3

今までの合計 446