メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

The Insignia 2-in-1 Handheld/Stick vacuum, over time, will lose its ability to work for extended amounts of time. Use this guide to access the battery for replacement and troubleshooting.

パーツ

パーツは指定されていません。

  1. Push down the black button to release the dust cup. Pull the dust cup up and away from handheld portion to remove.
    • Push down the black button to release the dust cup.

    • Pull the dust cup up and away from handheld portion to remove.

  2. Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.
    • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

    • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

  3. Pull apart the red and black wires. Do so for all of the wires. (Red x1, Black x2)
    • Pull apart the red and black wires.

    • Do so for all of the wires. (Red x1, Black x2)

  4. Remove the tape holding the battery to the black housing.
    • Remove the tape holding the battery to the black housing.

    • Slide the entire battery bundle out.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Trevor Rau

メンバー登録日: 2018年02月15日

270 ポイント

1ガイドが承認済み

チーム

USF Tampa, Team S16-G3, Boczar Spring 2018 USF Tampa, Team S16-G3, Boczar Spring 2018人のメンバー

USFT-BOCZAR-S18S16G3

4 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 4

過去 7 日: 29

過去 30 日: 31

今までの合計 263