IBM Thinkpad T60 Palm Rest Replacement

作成者： Dylan Kratochvil (そして 8 人のその他投稿者)

コメント: 1
お気に入り: 2
完了: 4

難易度

簡単

手順

所要時間

5 - 10 分

はじめに

Always power down the computer before attempting any installation/removal of any hardware components. Be sure to remove the AC adapter and all cables from the computer. If the computer has been on, wait several minutes before beginning the procedure to ensure all parts have cooled down.

ツール

これらのツールを購入する

Phillips #0 Screwdriver

$6.99

購入する

パーツ

パーツは必要ありません。

手順1 Battery

Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.

Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.
Use your finger to slide the tab to the right to unlock the battery.

翻訳

手順2

Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.

Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.
The battery is now disconnected.

翻訳

手順3 Palm Rest

Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.

翻訳

手順4

Turn the computer back over, so that the top is facing upwards.
Open the display to access the palm rest. Apply pressure to the sides of the palm rest so that it bends upwards in the middle. Then gently lift away from the computer.

翻訳

手順5

Slightly lift the palm rest away from the computer.
- The touchpad's data cable connects the palm rest to the base unit. BE CAREUL!
Detach the connector by pulling upwards on the white tab.

翻訳

Putting it back on should be covered too, as it’s really hard to get everything lined up. Would be nice for some tips on that. Took me and other experienced guy 45 minutes to get the thing back on, and have all the screws seat!

Glenn - 2018年04月12日返信