Huntington GA41PS-RDS Acoustic Guitar String Replacement

はじめに

If for any reason your Huntington GA41PS-RDS acoustic guitar string is broken, use this guide to replace it. The guide will teach you to replace any number of strings. Be careful when handling the strings, the pointed end if poked by can cause bleeding. Before using this guide identify all the strings that need to be replaced.

必要な工具と部品

手順1 Guitar String

Huntington GA41PS-RDS Acoustic Guitar String Replacement, Guitar String: 手順 1、 1の画像 1

Place your guitar on a flat surface where you can easily identify the broken string.

編集

手順2

Huntington GA41PS-RDS Acoustic Guitar String Replacement: 手順 2、 3の画像 3

Rotate the guitar pegs counter clockwise to loosen the broken string, until it can be removed by hand.

編集

手順3

Remove the bridge pin located at the lower end of the guitar.
Remove the other end of the broken string carefully. Keep the bridge pin removed.

編集

手順4

Huntington GA41PS-RDS Acoustic Guitar String Replacement: 手順 4、 3の画像 3

Take the ball end of the new string and insert it into the bridge hole.
Insert the bridge pin back into the hole. Pull the rest of the string slightly to make sure it is tight.
Select the correct string to replace. I will be using the thinnest E string for this guide

編集

手順5

Huntington GA41PS-RDS Acoustic Guitar String Replacement: 手順 5、 3の画像 3

Take the pointed end of the string and insert it into the string post.
Allow excess string to pass through. Tug on the string and make sure the string is parallel to the fret board.
Be careful. Do not hold too close to the sharp end of the string.