How to replace a broken towel hook on drywall

はじめに

Hey there!

On this guide, I will show you how to remove a broken towel hook on drywall, patch the hole, and install a new one!

Before you start, make sure you have the required tools and be careful around the screwdriver!

This guide will not take long, only around 10-15 minutes, but you’ll have to come back to this a few hours after you’re done installing the new hook to clean up the old hole.

Happy Fixing!

必要な工具と部品

手順1 Towel Hook

How to replace a broken towel hook on drywall, Towel Hook: 手順 1、 2の画像 1

How to replace a broken towel hook on drywall, Towel Hook: 手順 1、 2の画像 2

Using your Phillips screwdriver, remove both screws that are keeping your current (broken) drywall hook in place.
Make sure you remove both screws evenly, to avoid bending and damaging the screws and the drywall around it.

編集

手順2

After removing both screws, remove the plastic anchor screws from the drywall.
It will leave a big hole, but we will fix that!

編集

手順3

How to replace a broken towel hook on drywall: 手順 3、 3の画像 3

After removing the anchor screws, take your spatula and press it flush with the wall. Remove debris from the drywall to make the wall flat.

編集

手順4

Take some patching and with your spatula, apply it on and around the holes in order to fill it up to the surface of the wall.

編集

手順5

Select a new location for your new towel hook and, with one of the screws, mark the spot where you'll drill the holes.
Use your screwdriver to tap the two new locations, to make it easier to screw the anchors onto the wall.

編集

手順6

Take your new anchor screws and start drilling on your marked holes.
Keep screwing them into the drywall until they're flush with the wall.
Don't drill too far, or else it will damage the drywall and the towel hook will be uneven!

編集

手順7

How to replace a broken towel hook on drywall: 手順 7、 3の画像 3

Line up your new towel hook with the holes where the anchors are located.
Take your screws and start screwing them in manually so they stay in place.

編集

手順8

With your screwdriver, continue screwing the screws in until they're flush with the towel hook.

編集

手順9

Voila! Your new towel hook is installed!
But how about the hole we patched earlier?

編集

手順10

Press the sandpaper against the wall and scrub on and around the hole, to level it with the wall.
After doing that for a few seconds, your patch should be leveled and your problem, solved!

編集