はじめに

Sometimes a burning smell can come form the toaster. This could be caused by crumbs stuck in the unit so its suggested that you deep clean the Black and Decker Toast R Oven.

Make sure that the toaster is unplugged before you begin.
  • Make sure that the toaster is unplugged before you begin.

  • Turn the toaster over with its backside face down.

  • Remove the two Phillips #4 1cm screws that attach the side panels.

コメントを追加する

Pull downwards (towards the bottom of the unit) and outward to remove the side panels. Pull downwards (towards the bottom of the unit) and outward to remove the side panels.
  • Pull downwards (towards the bottom of the unit) and outward to remove the side panels.

コメントを追加する

Remove the metal vent piece that is below the door.
  • Remove the metal vent piece that is below the door.

  • This should slide off easily once both of the side panels are removed.

コメントを追加する

Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.
  • Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.

コメントを追加する

Remove the crumb tray (the bottom, metal panel) from the toaster unit.
  • Remove the crumb tray (the bottom, metal panel) from the toaster unit.

コメントを追加する

Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.
  • Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.

コメントを追加する

Remove the knobs by pulling them upward; they should slide right off.
  • Remove the knobs by pulling them upward; they should slide right off.

  • When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.

コメントを追加する

Unhook the bottom of the the display panel from the toaster unit.
  • Unhook the bottom of the the display panel from the toaster unit.

  • It will be a little tough to pry off, but don't be afraid to be forceful. You can use your hands, or pliers, to bend the metal piece backwards.

コメントを追加する

Begin to detach the back panel from the toaster unit.
  • Begin to detach the back panel from the toaster unit.

  • Then, unhook the rest of the display panel.

  • This will also be a little tough to get off, but don't be afraid to be forceful.

コメントを追加する

Now, you can clean the outside units of the toaster oven.
  • Now, you can clean the outside units of the toaster oven.

コメントを追加する

Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.
  • Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.

コメントを追加する

Finish removing the outside cover by lifting the lid upward.
  • Finish removing the outside cover by lifting the lid upward.

コメントを追加する

Remove the four Phillips #4 1 cm screws from the back of the unit.
  • Remove the four Phillips #4 1 cm screws from the back of the unit.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Jonathan

メンバー登録日: 2012年09月18日

105 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 2-10, Propen Fall 2012 Cal Poly, Team 2-10, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S2G10

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 8

過去 7 日: 29

過去 30 日: 155

今までの合計 7,690