1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic prying tool to remove the plastic frame surrounding the glass.

    コメントを追加する

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    コメントを追加する

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    コメントを追加する

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    コメントを追加する

    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    コメントを追加する

    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    コメントを追加する

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    コメントを追加する

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a Plastic Prying Tool to detach the white wiring connector from the circuit board.

    コメントを追加する

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    コメントを追加する

    • Pull the printer hood upward.

    コメントを追加する

    • Ribbon Cables connect electronics to one another and flat in appearance and flexible.

    • There are many ribbon cables throughout the printer. After opening up the casing of the printer the ones that are easily accessible are the ones that need cleaning. They all require the basic process to clean.

    コメントを追加する

    • In order to remove a ribbon cable pull the cable out of its port with a moderate amount of force. Remember the orientation of the cable if you can.

    コメントを追加する

    • After the cable is removed use compressed air to clear dust out of the port, and a dry soft cloth to clean the end of the cable.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Tanner Cook

メンバー登録日: 2012年09月26日

146 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 2-11, Propen Fall 2012 Cal Poly, Team 2-11, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S2G11

4 メンバー

6のガイドは作成済み

コメント1件

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 5

過去 30 日: 21

今までの合計 7,044