はじめに

If your LCD screen doesn't seem broken, you should check that it is properly connected to the motherboard. This is a much cheaper fix than buying a new LCD screen for the camera.

パーツ

パーツは必要ありません。

  1. Turn the camera upside down so you can access the battery chamber.
    • Turn the camera upside down so you can access the battery chamber.

    • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

    コメントを追加する

  2. Push the battery chamber latch in the direction of the front of the camera.  Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.
    • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

    コメントを追加する

    • With the battery chamber open, remove the old batteries.

    • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

    コメントを追加する

    • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

    コメントを追加する

    • Carefully pry away the rear housing cover with the plastic opening tool.

    コメントを追加する

    • Remove the rear housing cover by carefully pulling it away from the camera.

    コメントを追加する

    • Fold back the LCD screen and check that the cable coming from the screen is securely fastened to the motherboard.

    コメントを追加する

    • Fold the LCD screen back into the proper position.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Joseph Kelley

メンバー登録日: 2015年01月15日

228 ポイント

2のガイドは作成済み

チーム

USF Tampa, Team 7-1, Remmell Winter 2015 USF Tampa, Team 7-1, Remmell Winter 2015人のメンバー

USFT-REMMELL-W15S7G1

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 7

今までの合計 411