メインコンテンツにスキップ

ツール

パーツ

パーツは指定されていません。

  1. Turn off the water.
    • Turn off the water.

    • You do not want to forget this step.

  2. Disconnect the hose from the toilet by unscrewing the white plastic connector.
    • Disconnect the hose from the toilet by unscrewing the white plastic connector.

    • Excess water will spill out of this pipe, so have a bucket or rag nearby to catch it!

  3. Remove the plastic bolt protectors on either side of the base of the toilet.
    • Remove the plastic bolt protectors on either side of the base of the toilet.

    • Using a wrench, remove the nuts and washers from the bottom of the toilet where it's bolted to the floor.

    • Lift the toilet up from the floor.

    • Use caution when lifting it, it's going to be heavy!

    • Set the toilet off to the side.

  4. Remove the old wax ring and any debris from the toilet pipe in the floor where the toilet was, being sure not to let any debris fall down the pipe.
    • Remove the old wax ring and any debris from the toilet pipe in the floor where the toilet was, being sure not to let any debris fall down the pipe.

    • It may be nice to wear gloves for this step, as the old wax ring will be a bit dirty.

  5. Place new ring in the proper position for your toilet to rest on.
    • Place new ring in the proper position for your toilet to rest on.

    • Carefully position the toilet back over the hole, paying attention to the bolts.

  6. Tighten the nuts and bolts on each side of the toilet and replace the bolt-protectors.
    • Tighten the nuts and bolts on each side of the toilet and replace the bolt-protectors.

終わりに

Make sure you wash your hands!

Ahna Hensley

メンバー登録日: 2021年01月18日

145 ポイント

1ガイドが承認済み

チーム

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 19