How to Fix an Unwinding Tape Measure

はじめに

Use this guide to fix a non-retracting tape measure so that it retracts smoothly and on its own. The tape measure being fixed in this guide is the Ace 1in x 25ft Tape Rule. However, this guide should apply to any measuring tape needed. This guide requires a screwdriver to remove the screws depending on which kind of different screws tape measures may have. The purpose of this guide and why you should follow it is to make your tape measure retract smoother, faster and easier.

必要な工具と部品

手順1 How to Fix an Unwinding Tape Measure

How to Fix an Unwinding Tape Measure, How to Fix an Unwinding Tape Measure: 手順 1、 1の画像 1

Grab your broken tape measure and inspect so that it doesn't retract.
Make sure it is not locked.

編集

手順2

Remove the four 3mm Phillips #1 screws on the case around the clip.
Remove the 3mm Phillips #1 screw from the center of the clip.

編集

手順3

How to Fix an Unwinding Tape Measure: 手順 3、 3の画像 3

Separate the two halves of the case by pulling them apart.

編集

手順4

Begin unwinding your tape measure until you get to the end of the tape.
Remember to be careful when retracting so that the spring doesn't come out or you hurt someone when the whole tape is out.

編集

手順5

When the whole tape is out, slowly begin rolling it back in.
Roll it back in keeping your thumb firmly pressed on the wheel so that it goes back in smoothly and won't come out.
Once you start reaching the end, keep the tape straight with your thumb so that it retracts with no inconveniences.

編集

手順6

Once you have rolled the tape in again, place the top back on making sure the tape doesn't come out or roll out by itself.
Remember to keep your thumb on the wheel as you put on the top so that it doesn't come out and hurt anyone!

編集

手順7

Begin placing the screws back in to their respective places and screwing them back in tightly.
Do this as you apply pressure on the top so that no parts come out.

編集