メインコンテンツにスキップ

はじめに

Fans on electronic devices collect a lot dust over the years, so this guide will show how to clean the fan on this Toshiba projector in order to prevent overheating. To ensure maximum performance out of a fan, some oil can be added to keep the bearings lubricated and running in tip-top shape.

パーツ

パーツは指定されていません。

  1. Remove the two screws from the bottom plate as shown. Remove the two screws from the bottom plate as shown.
    • Remove the two screws from the bottom plate as shown.

  2. Remove the two screws on the bulb housing.
    • Remove the two screws on the bulb housing.

  3. Pull the tab up and pull the bulb out vertically. Some force will be required, but it will come out.
    • Pull the tab up and pull the bulb out vertically. Some force will be required, but it will come out.

  4. Using a can of compressed air, blow on the fan until all dust is gone.
    • Using a can of compressed air, blow on the fan until all dust is gone.

    • Oil can be added in with a dropper on the bearing if needed.

終わりに

To reassemble your device, follow these instructions in reverse order.

Bryan Underwood

メンバー登録日: 2018年04月02日

697 ポイント

5のガイドは作成済み

チーム

University of Memphis, Team S1-G3, Kim Spring 2018 University of Memphis, Team S1-G3, Kim Spring 2018人のメンバー

UM-KIM-S18S1G3

3 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 6

今までの合計 240