メインコンテンツにスキップ

Hover-1 Matrix Pad Replacement

必要な工具と部品

  1. Hover-1 Matrix Pad Replacement, Pad: 手順 1、 2の画像 1 Hover-1 Matrix Pad Replacement, Pad: 手順 1、 2の画像 2
    • Remove the screws on the back of the hoverboard using a Phillips #1 screwdriver.

    • Remove the back shell from the hoverboard.

  2. Hover-1 Matrix Pad Replacement: 手順 2、 1の画像 1
    • Remove the screws from the metal layer inside the hoverboard using a Phillips #1 screwdriver.

  3. Hover-1 Matrix Pad Replacement: 手順 3、 1の画像 1
    • Separate the upper shell of the hoverboard and the metal layer inside.

  4. Hover-1 Matrix Pad Replacement: 手順 4、 2の画像 1 Hover-1 Matrix Pad Replacement: 手順 4、 2の画像 2
    • Start by identifying the motherboard, which is the green pad shown in the picture.

    • Remove the screws on the corners of the motherboard with the Phillips #1 screwdriver and take it off.

    • There are cables attached to the motherboard so go ahead and unattach them.

  5. Hover-1 Matrix Pad Replacement: 手順 5、 3の画像 1 Hover-1 Matrix Pad Replacement: 手順 5、 3の画像 2 Hover-1 Matrix Pad Replacement: 手順 5、 3の画像 3
    • Use picture 1 as a guide and move the motherboard to the other side.

    • Identify the two black rubber buttons that are shown in the second picture.

    • Remove the two rubber buttons using the Phillips #1 screwdriver.

  6. Hover-1 Matrix Pad Replacement: 手順 6、 1の画像 1
    • Removing the rubber buttons in the previous step allows you to take the pad off.

    • Finally, take off the old pad and put on a new pad.

終わりに

To reassemble your device, follow these instructions starting with step number 6 and finishing with step number 1.

ある他の人がこのガイドを完成しました。

作成者

4人の作成者と共同で作成されました。

Jici Zhuang

メンバー登録日: 10/22/18

362 ポイント

2のガイドは作成済み

チーム

UC Davis, Team S7-G2, Lore Fall 2018 UC Davis, Team S7-G2, Lore Fall 2018人のメンバー

UCD-LORE-F18S7G2

3 メンバー

4のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 12

今までの合計 347