はじめに

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

パーツ

パーツは必要ありません。

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

    コメントを追加する

  2. Slide off the plastic side panel.
    • Slide off the plastic side panel.

    コメントを追加する

    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

    コメントを追加する

    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

    コメントを追加する

    • Slide off the other plastic side panel.

    コメントを追加する

    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Luke Imai

メンバー登録日: 2018年10月08日

133 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team S15-G5, White Fall 2018 Cal Poly, Team S15-G5, White Fall 2018人のメンバー

CPSU-WHITE-F18S15G5

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 16

過去 30 日: 16

今までの合計 32