メインコンテンツにスキップ

はじめに

You will need a Phillips #2 screwdriver and a soldering iron.

パーツ

パーツは指定されていません。

  1. Flip the Hover-1 Chrome upside down.
    • Flip the Hover-1 Chrome upside down.

    • Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.

    • Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

  2. Lift the shell without the speaker grille and unplug the battery.
    • Lift the shell without the speaker grille and unplug the battery.

  3. Lift the shell with the speaker grille. Unplug the speaker.
    • Lift the shell with the speaker grille.

    • Unplug the speaker.

    • Unplug the LEDs.

    • Unplug the power button

    • Unplug the charging port.

  4. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  5. Disconnect the speaker cable. Disconnect the cable that travels to the other sensor board. Disconnect the cable that travels to the other sensor board.
    • Disconnect the speaker cable.

    • Disconnect the cable that travels to the other sensor board.

  6. Disconnect the smaller connector midway on the cable. Disconnect the larger connector midway on the cable. Disconnect the larger connector midway on the cable.
    • Disconnect the smaller connector midway on the cable.

    • Disconnect the larger connector midway on the cable.

  7. Remove the four 12mm Phillips #2 screws securing the sensor board.
    • Remove the four 12mm Phillips #2 screws securing the sensor board.

  8. Locate the five solder locations on the underside of the gyroscope sensor board. Plug in soldering iron and wait for the tip tip to reach its target temperature.
    • Locate the five solder locations on the underside of the gyroscope sensor board.

    • Plug in soldering iron and wait for the tip tip to reach its target temperature.

    • Rest the tip of the iron on the solder and wait for the solder to melt. The wire will drop out of the sensor board.

    • Be aware of where the tip of the soldering iron is at ALL times. Put on safety glasses before picking up the soldering iron. Turn on a fan and face it towards the device to vent harmful fumes away from the solderers face.

まとめ

To reassemble your device, follow these instructions in reverse order.

Nick McGuire

メンバー登録日: 2018年10月08日

539 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team S4-G1, White Fall 2018 Cal Poly, Team S4-G1, White Fall 2018人のメンバー

CPSU-WHITE-F18S4G1

4 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 105