-
-
Flip the Hover-1 Chrome upside down.
-
Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.
-
Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.
-
-
-
-
-
Use a Phillips #2 screwdriver to remove the two 2 mm screws on either side of the LEDs.
-
Remove the LED board.
-
The LEDs are not symmetrical. This step is for the right side of the board, next to the power button. The left side is covered next.
-
-
このガイドを埋め込む
サイズを選択し、以下のコードをコピーして、このガイドを小さなウィジェットとしてサイト/フォーラムに埋め込みます。
プレビュー