はじめに

If the case of the shear is cracked and you are concerned about debris getting into the device this guide is what you are looking for.

Locate and remove the six 1.5 cm screws marked on the picture from the shear with a Phillips head #2 screwdriver.
  • Locate and remove the six 1.5 cm screws marked on the picture from the shear with a Phillips head #2 screwdriver.

コメントを追加する

Pull face plate away from the body of the device. Replace similarly, but take caution of loose wires that might have been moved by the removal of the face plate. If the plate with the screw sockets was replaced then the wires will need to be put back into the the depressions on the new plate for the device to be closed up properly. See photo with the blades on the right for proper wire placement.
  • Pull face plate away from the body of the device. Replace similarly, but take caution of loose wires that might have been moved by the removal of the face plate.

  • If the plate with the screw sockets was replaced then the wires will need to be put back into the the depressions on the new plate for the device to be closed up properly. See photo with the blades on the right for proper wire placement.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Adam soto

メンバー登録日: 2015年01月30日

301 ポイント

3のガイドは作成済み

チーム

USF Tampa, Team 17-5, Watkins Winter 2015 USF Tampa, Team 17-5, Watkins Winter 2015人のメンバー

USFT-WATKINS-W15S17G5

3 メンバー

4のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 97