メインコンテンツにスキップ

はじめに

If your Invoke is experiencing problems with powering on after being plugged in, there could be an issue with a weak or broken power port.

パーツ

パーツは指定されていません。

  1. Use a metal spudger to remove rubber bottom. Use a metal spudger to remove rubber bottom.
    • Use a metal spudger to remove rubber bottom.

  2. Use a #10 Torx screwdriver to remove four 14 mm screws. Use a #10 Torx screwdriver to remove four 14 mm screws.
    • Use a #10 Torx screwdriver to remove four 14 mm screws.

  3. PCラップトップ用バッテリー

    An easy fix for a big power boost.

    ショップを見る

    PCラップトップ用バッテリー

    An easy fix for a big power boost.

    ショップを見る
  4. Firm grip the bottom and wiggle upwards to remove bottom. Firm grip the bottom and wiggle upwards to remove bottom.
    • Firm grip the bottom and wiggle upwards to remove bottom.

  5. Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports. Pull board up lightly. Pull board up lightly.
    • Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports.

    • Pull board up lightly.

  6. Pull cable to disconnect board from device. For replacement of service port, you will have to replace whole board that the port is attached to.
    • Pull cable to disconnect board from device.

    • For replacement of service port, you will have to replace whole board that the port is attached to.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Angel A. Grageda

メンバー登録日: 2018年10月02日

635 ポイント

4のガイドは作成済み

チーム

Eastern Washington University, Team S2-G2, Munoz Fall 2018 Eastern Washington University, Team S2-G2, Munoz Fall 2018人のメンバー

EWU-MUNOZ-F18S2G2

3 メンバー

5のガイドは作成済み

コメント1件

can I buy that power port circuit board from HK direct?

crokeclan - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 67